iPECS UCM
Installation Manual Issue 1.1
71
- 22 54 -
- 23 55 -
- 24 56 -
- 25 57 -
- 26 58 -
- 28 60 -
- 29 61 -
- 31 63 -
- 32 64 -
The internal module of UCM-MDTMX2 has E1 / T1 / PRI / SS7 selector switch, allowing you to choose a
protocol for your application.
Protocol S/W and Shunt Setting
The following figure shows the case of using only E1 links for Port 1 and port 2.
SW3 (Port1) SW4 (Port2)
Figure 3-36 Protocol Port selection switch
The UCM-MDTMX2 modules have a function that can be set inside the line impedance, it is to change the
initial value according to the E1 / T1 line interfaces. Special shunt location change is unnecessary as a
MDTM2
To Next Page
Loading...
