2 System
2.1 Features
The IPEmotion PlugIn IPETRONIK-X offers you the ability to use IPEmeasure Ethernet technology within
IPEmotion. The devices of the Mx-/Sx-Series in combination with IPEmotion software allows an unlimited
and clear use of the IPEmotion main navigation tabs Acquisition, View, and Analysis.
The Ethernet technology of the X-Series modules offers the following user benefits:
Significantly higher performance compared to CAN
No separate hardware for the connection of a notebook / a PC is required
High market acceptance in office communication and industry
The X-Serie modules, basing on the well-proven IPETRONIK M and SIM modules have been extended to
meet higher requirements, e.g. in the field of the service strength (RLDA = Road Load Data Acquisition).
The specific properties are:
Higher channel sampling rates (Mx-SENS up to 10 kHz, Sx-STG up to 40 kHz,
Mx-SENS2 4 fast up to 400 kHz)
Higher aggregate sampling rates (Mx-SENS: up to 80 kHz, Sx-STG: up to 320 kHz,
Mx-SENS2 4 up to 400 kHz)
> 4 MHz total sampling rate within a system:
Support of higher numbers of fast channels
Smaller housing construction
IPETRONIK X system distinguishes currently between the following devices:
Mx-SENS 8, Mx-SENS2 4, Mx-SENS2 4 (PlugIn ≥ V02.01 required)
Sx-STG, Mx-STG2 (PlugIn ≥ V02.04 required)
Each device is an independent acquisition system and can be used as a stand-alone devices, as well as, in
combination with other modules (Mx-SENS and Sx-STG in the system network).
2.2 Accessories
2.2.1 USB2ETH Mx/Sx
It is possible to use the USB2ETH adapter for notebooks and PCs which don’t have any free Ethernet
interface, This adapter allows a connection of
the module chain to a free USB interface.
To Next Page
Loading...