Important and general information
IPETRONIK PlugIn X V02.14.00
Warranty
Products, accessories and services have a 24 months warranty.
All product data, specifications, drawings, etc., correspond to the current condition of the indicated creation
date. For the purpose of optimizing technical processes and production, some details of our modules and
accessory components may be modified at any time without prior notification.
Although the present document has been prepared with the utmost attention to detail, it may not be exempt
of misprints, typing or transcription errors. These errors are not covered by any warranty.
1.2 General information
1.2.1 About this manual
This manual describes the X-System structure and how to use the IPETRONIK IPEmeasure modules
Mx-SENS2 4, Mx-SENS2 8, Mx-SENS 8, Mx-STG2 and Sx-STG with IPEmotion (PlugIn IPETRONIK-X).
© 2020 All rights reserved !
System requirements
IPEmotion PlugIn IPETRONIK-X
Descriptions in this documentation refer to the current release. In contrast to previous versions (< V02.00),
current and subsequent releases also support a configuration and data acquisition with IPETRONIK CAN
modules which are connected to the PC by a CAN interface. So far the PlugIn IPETRONIK CAN was
necessary for this operation mode. Please note, that modules require the latest firmware.
This PlugIn is supported by IPEmotion 2017 / IPEmotion 2018 (≥ V07.00.00) and Windows 7 / 8.1 / 10
(32 bit and 64 bit systems). Microsoft .NET 4.5.1 Framework is required!
Please follow the recommendations at 5.1 PlugIn IPETRONIK-X .
PTP driver and Windows 7
In case of an error message during the PlugIn installation under Windows 7 (Windows requires a digital
signed driver.), Windows needs to be updated in order to ensure the identification of the driver signature
certificate. Refer to 5.1.4 PTP driver > Driver signature
Some firewall settings might block the PTP communication. In this case, the PlugIn uses an
alternative algorithm to synchronize the measurement between X devices and PC. However,
timestamps would be more inaccurate, this should be avoided by configuring the firewall in a
way to accept PTP communication.
To Next Page
Loading...
Need help?
General