TM3215, 3245, 3265
30
Hazard Light Switch, 4
FIG. 42 - Press switch to turn on hazard lights. Both
flashing amber warning lights will operate at the same
time.
CAUTION: Hazard lights must be used any
time tractor is driven on public roadway.
Consult local agencies for other marking re-
quirements.
FIG. 43: Turn / hazard indicator lights, 5 and 6, will oper-
ate with front and rear combination lights. This provides
operator with easy indication of warning light selection.
Power Take-Off (PTO) Switch
(Hydrostatic Transmission)
FIG. 44: PTO switch, 7, is used to engage and disen-
gage the PTO drive system.
The switch must first be turned to right and then pulled
up to engage PTO. When engaged, the PTO indicator
light in the indicator light strip will illuminate.
A PTO selectable switch, 8, is used to adjust PTO clutch
modulation.
Push on: soft start (button depressed illuminated) - for
high inertia loads
Push off: standard start (button out and not illuminated)
IMPORTANT: PTO switch is equipped with a lock-out
to prevent accidental engagement of
PTO system. To engage PTO, first turn
switch clockwise and then pull up it. DO
NOT FORCE SWITCH.
NOTE: PTO switch, 7, must be used in conjunction
with rear PTO selector lever, to left of opera-
tor’s seat, when rear PTO is used. Refer to
“Operation” section for complete details.
When PTO control switch is “ON” the engine
cannot be started. Always switch off PTO to
start engine.
This switch is equipped with only “Independent”
PTO specification model.
“Independent PTO” is not equipped on “Me-
chanical transmission” type tractor.
WARNING: Always shut off PTO and shut
off tractor engine before servicing PTO-
driven implement. Allow all movement and
motion to stop before leaving operator’s
seat.
4
8
7
4
g
†
b o
M
M
l
65
FIG. 42
FIG. 44
FIG. 43
To Next Page
