OPERATION
59
CAUTION: Always lower implement to
ground, shut off engine and relieve system
pressure (by operating control levers with
engine off) before connecting or discon-
necting implement hoses.
CAUTION: Make sure all hydraulic hoses,
couplers and cylinders are in good condi-
tion before use. Damaged equipment is dan-
gerous.
FIG. 103: Most implements require double-acting hy-
draulics. Each implement cylinder will have 2 hoses con-
nected to it.
When single-acting service is required (cylinder with
only 1 hose), the inner “A” coupler will be used and se-
lector function, 1, must be turned to the left.
NOTE: For normal double-acting operation selector
function must be turned to the right.
ROLL OVER PROTECTIVE STRUCTURE (ROPS)
Rear ROPS Type
Tractor is equipped with fold-down ROPS which can
be folded down and the tractor functionally used in that
condition for low clearance situation such as orchards,
vineyards, barns, and chicken houses, etc.
Always raise ROPS in to the fully erect position at the
earliest time.
ROPS must be maintained in this fully raised position at
all times unless practical operation of the tractor dictates
other wise, (as described above).
FIG. 104: Remove linchpin, 1, and pin, 2, then tilt the
ROPS rearward care fully.
CAUTION: Do not weld, drill, bend or
straighten. Make sure all components are in
correct working order to provide the intend-
ed protection.
Only original bolts, or equivalent replace-
ments, must be used and tightened to cor-
rect torque value Make sure both “hinge”
joints are properly secured.
NOTE: To prevent PIN ASSY, 3, from being lost, insert
the ring of wire onto knob and assemble it.
1
1
2
1
3
FIG. 103
FIG. 104
FIG. 105
To Next Page
