TM3215, 3245, 3265
46
1
4
5
2
3
1
2
FIG. 76
FIG. 77
FIG. 75
CAUTION: Before leaving the tractor unat-
tended, make sure parking brakes are ap-
plied, rear mounted implement is lowered to
the ground and the key is removed from the
ignition switch.
FIG. 75: Always park tractor on level area whenever
possible. If hillside parking is necessary, securely block
both rear wheels as shown.
Hydrostatic Transmission
FIG. 76: To stop the tractor with a hydrostatic transmis-
sion, release the forward HST pedal, 3.
This action will stop forward travel. Move the throttle
lever, 1, forward to reduce engine speed, depress the
brake pedal, 2, and set the parking brake lever, 3. Move
the range gear shift lever, 5, to neutral position.
Allow the engine to idle several minutes to allow even
cooling, then turn the main switch to the “off” position,
shutting off the engine.
Lower the 3-point hitch and remove the key from the
main switch.
CAUTION: Make sure brakes are adjusted
evenly.
CRUISE CONTROL (HYDROSTATIC TRANSMISSION)
Setting Cruise Control
FIGS. 77 & 78: Depress the forward HST pedal, 2, and
keep your intended speed. And shift the cruise control
lever, 3, to forward direction and set it.
CAUTION: If it is adjusted only by the cruise
control lever without pedal operation, the
cruise control lever will be deformed. Never
fail to operate the forward pedal and set
with the lever.
To Next Page
