Iseki TM3265 - Rear PTO Shaft

OPERATION
49
Rear PTO Shaft
FIG. 82: PTO shaft, 1, (6 splines, 35 mm (1-3 / 8”)) is
provided at rear of the tractor to provide power to rear-
mounted PTO driven implement.
Protective cover shall be installed when it is not in use.
Normal rear PTO shaft operating speed:
Mechanical Transmission
(TM 3215) 545 min
-1
@ 2500 engine revolution speed
(TM 3245 / TM 3265) 567 min
-1
@ 2600 engine revolution speed
Hydrostatic Transmission
(TM 3215) 550 min
-1
@ 2500 engine revolution speed
(TM 3245 / TM 3265) 571 min
-1
@ 2600 engine revolution speed
IMPORTANT: When the rear PTO is used with a
3-point mounted equipment, it may be
necessary to remove the drawbar, at
rear of the tractor. Some types of mount-
ed equipment, when lowered, may allow
the PTO shaft to contact drawbar.
FIG. 83: PTO shield cover
CAUTION: Make sure all PTO shields are in-
stalled on the tractor and equipment. Before
cleaning or adjusting the tractor or PTO-
driven machine, SHUT OFF THE ENGINE
AND DISENGAGE PTO.
1
FIG. 82
FIG. 83