VT50 – Operation
5.3.8.3 Network member
To change to the network members information proceed as follows:
1. Press on the "Network members" button on the touchscreen or turn the scroll
wheel until the button is highlighted in white and then press on the scroll
wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
Network members are identified.
The following mask opens:
You have the following operating options:
Show information
Filter list
Reset filter
Delete all object pools
Delete current object pool
Note
Buttons of implements, whose object pool has been loaded once,but which are not
currently connected, are shown greyed out.
49
To Next Page
Loading...