ITEM C 1-Series - Page 8

Page 8
8.8.3 Pin assignment [X5] ......................................................................... 97
8.8.4 Cable type and design [X5] ................................................................ 98
8.8.5 Connection notes [X5] ...................................................................... 98
8.9 Connection: USB [X19] .................................................................................... 99
8.9.1 Device side [X19] ............................................................................ 99
8.9.2 Counterplug [X19] ........................................................................... 99
8.9.3 Pin assignment [X19] ....................................................................... 99
8.9.4 Cable type and design [X19] .............................................................. 99
8.10 SD/MMC card ............................................................................................. 100
8.10.1 Supported card types ..................................................................... 100
8.10.2 Supported functions ....................................................................... 100
8.10.3 Supported file systems ................................................................... 100
8.10.4 File names ................................................................................... 100
8.10.5 Pin assignment SD/MMC card .......................................................... 101
8.10.6 BOOT-DIP-Switch ........................................................................... 102
8.11 Notes on safe and EMC-compliant installation ..................................................... 103
8.11.1 Definitions and terms ..................................................................... 103
8.11.2 General information on EMC............................................................. 103
8.11.3 EMC areas: first and second environment ............................................ 104
8.11.4 EMC-compliant cabling ................................................................... 104
8.11.5 Operation with long motor cables ...................................................... 105
8.11.6 ESD protection ............................................................................. 106
9 ADDITIONAL REQUIREMENTS FOR THE SERVO DRIVES CONCERNING THE UL APPROVAL ... 107
9.1 Circuit protection ......................................................................................... 107
9.2 Wiring and environment regards ...................................................................... 107
9.3 Motor temperature sensor .............................................................................. 107
10 INITIAL OPERATION .............................................................................................. 108
10.1 General notes on connection ........................................................................... 108
10.2 Tools / material ........................................................................................... 108
10.3 Connecting the motor .................................................................................... 108
10.4 Connecting the item servo positioning controller C 1-Series to the power supply .......... 109