Installation
Power supply
The 96RM-E needs a supply voltage to operate.
The supply voltage is connected on the rear of the device
via terminal blocks.
Before connecting the supply voltage, ensure that
the voltage and frequency correspond to the details
on the ratings plate!
Fig. connection example of the supply voltage
to a UMG 96RM
Circuit breaker
Fuse
N
L
m
• The supply voltage must be connected
through a fuse according to the technical
data.
• If installed in a building, a disconnector
or circuit-breaker must be provided for
the supply voltage.
• The disconnector must be installed
near the device and easily accessible
to the user.
• The switch must be marked as the circuit
breaker for this device.
• Voltages which are over the permitted
voltage range can destroy the device.
To Next Page
Loading...
