JetMove D203-JC24X 12.7 Status LEDs, Mode Selector
Jetter AG 109
12.7 Status LEDs, Mode Selector
12.7.1 LEDs
Fig. 31: Status LEDs
Status LEDs
Vout (green) Supply voltage for the digital output
driver is OK
ERR2 (red) Error in the output driver
Overload, short circuit,
overtemperature of one or more
outputs
VCC2 (green) Supply voltage for the logic circuit is OK
ERR1 (red) Error; error description in register 2008
RUN (green) Operating system of the integrated
controller is active
SD (yellow) Read or write access is being made to
the SD card
To Next Page
Loading...
