Jetter JetMove D203 - Diagnostics; Error Messages

JetMove D203 9.1 Error Messages
Jetter AG 81
9 Diagnostics
9.1 Error Messages
INFO
In the case of a error message, the letter "F" and two successive numbers
appear on the 7-segment display every second.
Fault Message Table for the JetMove D203
Error Number Type of Error Description Response to
Errors
Troubleshooting
F 00 Hardware Errors Internal hardware
defect
– Immediate
pulse disable
– Cut drive controller
from power lines
– Return the amplifier
for repair
F 01 Internal voltage
supply error
One or more
power supply
voltages are
beyond their limits
– Immediate
pulse disable
– Cut drive controller
from power lines
– Return the amplifier
for repair
F 03 Motor cable
breakage
The motor cable is
broken
Please be careful:
The motor cable is
tested when the
drive controller is
enabled for the
first time
– Immediate
locking of
controller
– Check the motor
cable connections
– Acknowledge failure
F 04 Overvoltage in
the DC link
A DC link voltage
of> 480 V has
been detected
– Immediate
locking of
controller
– Check input voltage
supply
– If the motor is used
as generator, reduce
the regenerating
power
– Acknowledge failure