Jetter JetMove D203 - Motor Connection

7 Description of Connections
50 Jetter AG
7.2 Motor Connection
7.2.1 Assignment and Specification
Specification of the connector for terminal X74/84
• 4-pin screw clamping terminal (type PC 4/ 4-ST-7.62)
• Cross-sectional area of connecting cable: 0.25 ... 4.0 mm
2
(AWG 24 ... AWG 12)
• Bladed screw-driver: 0.6 x 3.5 x 100 mm
• Stud torque for the screw clamping terminal:
0.5 Nm ... 0.6 Nm (4.4 ... 5.3 lbf-inch)
Specification of the motor cable
• Cable size: 4 * 0.75 mm² (AWG 18(4))
• Material: Copper
• Temperature class: 60 °C
• Stripping length of cores: 6 mm
• Bootlace ferrules are recommended
Cable shielding
• Braided copper shield of 80 % coverage min.
Connection of the motor to the digital servo amplifier JetMove D203 has to be done
following the wiring diagram below. Connection of the brake is optional.
Fig. 9: Connection of motor lines
Strain relief
of the
JM-D203
green / yellow
PE
core 1
phase 1
core 2
phase 2
core 3
phase 3
Motor
The shield is extensively
connected with the
metallised connector
housing
brake -
brake +
X74/X84
W2
V2
U2
PE
internal circuit
24V
0 V
X72/X82