7 Description of Connections
56 Jetter AG
7.3 Resolver Connection
7.3.1 Specifications
Specification of the connector for terminal X71 / X81 (ENCODER)
• 15-pin male SUB-D connector
• Metallized enclosure
Specification of the resolver cable
• Cable size: 4 * 2 * 0.14 mm² (AWG 26(8)) min.
• Cores have to be shielded and twisted in pairs and must be included in an overall
shielding
• The shield must be connected to the connector housings on both ends of the
cable with the greatest possible surface area.
• Material: Copper
• Temperature class: 60 °C
• Maximum cable length: 50 m
7.3.2 Resolver cable with mating connector
INFO
The compatible resolver or HIPERFACE mating connector can be ordered from
Jetter AG by specifying the part number below:
Article # 15100069 Resolver / HIPERFACE
The complete resolver cable connecting the servo amplifier series JetMove D203
and synchronous servo motors can be ordered from Jetter AG by specifying the
following item number (KAY) and the respective cable length in cm:
KAY_0823-xxxx For the JetMove D203 servo amplifier series
To Next Page
Loading...
