Jetter JetMove D203 - Digital Inputs, Logic Power Supply

7 Description of Connections
70 Jetter AG
7.7 Digital Inputs, Logic Power Supply
Specification of terminal X10
• 2-pin screw clamping terminal (type MC 1.5/ 2-ST-3.5)
• Cross-sectional area of connecting cable: 0.14 ... 1.5 mm
2
(AWG 26 ... AWG 16)
with bootlace ferrules in a plastic sleeve: 0.25 ... 0.5 mm
2
(AWG 24 ... AWG 20)
• Bladed screw-driver: 0.4 x 2.5 mm
• Stud torque for the screw clamping terminal: 0.22 Nm (1.95 lbf-inch)
Specification of terminal X72 / X82
• 10-pin screw clamping terminal (type MC 1.5/ 10-ST-3.81)
• Cross-sectional area of connecting cable: 0.14 ... 1.5 mm
2
(AWG 26 ... AWG 16)
with bootlace ferrules in a plastic sleeve: 0.25 ... 0.5 mm
2
(AWG 24 ... AWG 20)
• Bladed screw-driver: 0.4 x 2.5 mm
• Stud torque for the screw clamping terminal: 0.22 Nm (1.95 lbf-inch)
Power Supply - Logic Circuit
Terminal
X10
Signal Description Specification
DC 24 V Power
supply
Power supply of the logic
unit
DC 20 ... 28.8 V
(I < 1.3 A)
0 V Common
ground
Ground for logic power
supply
Digital Inputs, Brake Terminals
Terminals
X72/X82
Signal Description Specification
DC 24 V
OUT
Sensor
supply
voltage
• This voltage output can
be used for supplying
the reference and limit
switches.
DC 20 .. 28.8 V
(I < 100 mA)
REF Reference
switch
(Input)
• Depending on the
parameter setting, this
input is used for
reference run
•DC24 V
• 7.5 mA max.
• Operating point:
< 6 V low,
> 15 V high
NC or NO contact
0 V Common
ground
Ground
*)
for all
inputs