12 Option -JC24X
112 Jetter AG
12.8 Setting the IP Address
There are four ways of assigning an IP address to a -JC24X. The actually used IP
address can be read from register 2931.
12.8.1 Default IP address
If, at switching on the integrated controller, both address switches are in position '0',
the JetControl will have the default IP address 192.168.10.15.
In case of any uncertainties with regard to the IP address used, you can use this
"loophole" to set the JetControl to a defined state.
12.8.2 IP address from the configuration
memory
If, at switching on the integrated controller, both address switches are in position 'F',
the -JC24X will have the IP address which has been stored to the configuration
memory.
The configuration memory can be accessed via the configuration file "/System/
cfgvar.ini" or via registers 10131 through 10145 and 10200 through 10219.
Configuration File
To gain access to the configuration file "/System/cfgvar.ini" via FTP the user must
have administrator rights.
This file has the same structure as a Windows *.INI file:
[CFGVAR]
Version = 5
IP_Address = 192.128. 10. 97
IP_SubNetMask = 255.255.255. 0
IP_DefGateway = 192.128. 10. 1
BasePort = 50000
IP_DNS = 192.118.210.209
HostNameType = 1
HostName = JM-D203-JC24X
NOTICE!
In no case change the version number.
To Next Page
Loading...
