JetMove D203 7.4 HIPERFACE Connection
Jetter AG 59
7.4 HIPERFACE Connection
7.4.1 Specifications
Specification of the connector for terminal X71 / X81 (ENCODER)
• 15-pin male SUB-D connector
• Metallized enclosure
Specification of HIPERFACE cable
• Cable size:
Minimum 4 * 2 * 0.14 mm² + 2 * 0.5 mm² (AWG 26(8) + AWG 20(2)).
2 * 0.5 mm² (AWG 20(2)) must be used for power supply and for GND.
• Twisted-pair cables shielded with the all-over shield must be used;
The signal lines must also be twisted in pairs:
Sine + and reference sine
Cosine + and reference cosine
DATA - and DATA +
0 V and voltage supply
• The shield must be connected to the connector housings at both ends of the cable
with the greatest possible surface area.
• Material: Copper
• Temperature class: 60 °C
• Maximum cable length: 50 m
7.4.2 HIPERFACE cable with mating connector
INFO
The resolver respectively HIPERFACE mating connector can be ordered from
Jetter AG by specifying item number 15100069.
The complete resolver cable connecting the servo amplifier series JetMove D203
and synchronous servo motors can be ordered from Jetter AG by specifying the
following item number (KAY) and the respective cable length in cm:
KAY_0923-xxxx For the servo amplifier series JetMove D203
To Next Page
Loading...
