7 Description of Connections
58 Jetter AG
Mating connector of the resolver (solder side)
Fig. 11: RC series mating connector of the resolver (internal thread M23)
INFO 1
Selecting signal:
By means of the selecting signal, a coding can be carried out, in order to diagnose
mixing up the two encoder connectors. This is only useful, if one of the two
encoder connectors has got this coding. For coding, this pin must be connected
to 0 V. A coded encoder connector can be checked via the application program of
the controller.
Solder Side
12
9
11
5
7
8
6
4
10 2
1
3
To Next Page
Loading...
