Jetter JetMove D203 - IP Address Based on the Address Switch Position

12 Option -JC24X
114 Jetter AG
12.8.3 IP address based on the address switch
position
In all other address switch positions, the IP address is taken out of the configuration
memory; the least significant byte is substituted by the position of the address
switches.
The IP address of a -JC24X is made up according to the following pattern:
Fig. 33: IP address pattern
• The first three bytes (e.g. 192.168.1) are taken out of the configuration memory.
• The higher-order nibble of the fourth byte is set by means of the address switch
"High" (value range: 0 through 15).
• The low-order nibble of the fourth byte is set by means of the address switch
"Low" (value range: 0 through 15).
NOTICE!
Do not change the version number contained in register 10131.
192 . 168 . 1 .
1
1
1
1
0
0
0
0
=C =5
Address
High Low
High Low