Jetter JetMove D203 - Page 61

JetMove D203 7.4 HIPERFACE Connection
Jetter AG 61
Dimensions of the HIPERFACE mating connector are specified in millimeters.
Fig. 12: HIPERFACE connection with set supply voltage
INFO 1
Supply voltage:
With the help of the sense resistor, the supply voltage can be set for the encoder.
The resistance can be calculated by the following formula:
In order to set the HIPERFACE supply voltage of 8.5 V, a resistor of 1.33 K is
needed. .
RU()
4700Ω
U5V–
------------------=
Ω
Hiperface Encoder
JetMo ve D203
X71 / X81:
15-Pin
SU B- D
Connector
Se n s e +
Se n se -
+ 8.5 V
0 V
Si n +
Cos+
Da ta +
Si n -
Cos-
Da ta -
6
14
5
13
1
2
3
9
10
11
+ 8.5 V
0V
Si n +
Cos+
Da ta +
Si n -
Cos-
Da ta -
INFO 2
Selecting signal:
By means of the selecting signal, a coding can be carried out, in order to diagnose
mixing up the two encoder connectors. This is only useful, if one of the two
encoder connectors has got this coding. For coding, this pin must be connected
to 0 V. A coded encoder connector can be checked via the application program of
the controller.