Jetter JetMove D203 - Page 64

7 Description of Connections
64 Jetter AG
Fig. 14: Sin-cos encoder connection of +5 V supply voltage
Fig. 15: Sin-cos encoder connection with a feedback control of the supply
voltage
INFO 1.1
Supply voltage +5 V at the JetMove D203:
If the sense wires are not connected, the supply voltage of +5 V is issued at the
JetMove D203. Due to performance degradation, a lower voltage might be
supplied to the encoder.
Si n - C o s En c o d e r
JetMove D203
X71 / X81:
15-pin
SUB- D
connector
Se n s e +
Se n se -
+ 5...8.5V
0 V
Si n +
Cos+
Ind e x+
Si n -
Cos-
Ind ex-
6
14
5
13
1
2
3
9
10
11
+ 5...8.5V
0 V
Si n +
Cos+
Ind ex+
Si n -
Cos-
Ind ex-
INFO 1.2
Supply voltage +5 V at the encoder:
With the help of the sense connections, the supply voltage can be controlled in a
way that +5 V are supplied to the encoder. Wiring should be carried out as follows:
Si n - C o s- E n c o d e r
JetMove D203
X71 / X81:
15-Pin
SUB-D Connec tor
Se n s e +
+5V
0 V
Si n +
Cos+
Ind ex+
Si n -
Cos-
Ind ex-
Se n se -
+5
0V
Si n +
Cos+
Ind e x+
Si n -
Cos-
Ind e x-
5 V
6
5
13
14
1
2
3
9
10
11