Jetter JetMove D203 - Page 78

7 Description of Connections
78 Jetter AG
Pin Assignment - Analog Input Connector for Axis A
Shield
X18 Connect shield with the greatest possible surface area!
Use metallized housing only!
Pin Signal
6 Analog signal (0 - 10 V to pin 8)
8 Reference of the analog signal
(not connected with 0 V of the controller)
Shield
Pin Assignment - Analog Input Connector for Axis B
Shield
X19 Connect shield with the greatest possible surface area!
Use metallized housing only!
Pin Signal
6 Analog signal (0 - 10 V to pin 8)
8 Reference of the analog signal
(not connected with 0 V of the controller)
Shield