SECTION 3 - MACHINE CONTROLS, INDICATORS, AND MACHINE OPERATION
3-28 31217162
Driving in Reverse
1. Position the power selector switch at the ground control sta-
tion to platform.
2. Position the emergency stop switch at the platform control
station to the on position.
3. Press the drive switch and move the drive controller rear-
ward and hold for the duration of travel.
Drive speed is determined by the distance the joystick is
moved from the center off position. Do not activate the high
drive speed switch when traveling in reverse.
Traveling on a Grade
If traveling at high speed up a grade and the incline exceeds 7° to
10° (depending on machine configuration), the drive function
will cut back to low speed. The drive pump will shift back into
high speed once the incline decreases to 5° to 8° (depending on
machine configuration). There will be a two second delay before
the machine returns to high speed.
If traveling at high speed down a grade and incline exceeds 12° -
14° (depending on machine configuration), the drive function
will cut back to low speed. The drive pump will shift back into
high speed once the incline decreases to 5° - 8° (depending on
machine configuration). There will be a two second delay before
the machine returns to high speed.
To Next Page
Loading...
