SECTION 3 - MACHINE CONTROLS, INDICATORS, AND MACHINE OPERATION
31217162 3-33
NOTE: If a 2/5 flash code through the system fault light at the platform
control station, the machine is unable to level. Reposition and try
again.
6. To retract the leveling jacks, press the function button, then
move the joystick backward. The platform alarm will sound
two times to indicate this is complete.
NOTE: The tilt indicator shows when the machine is outside the allow-
able lifting operation. When the machine reaches a position
within level of the specific market specification, the tilt light will
go out. Once the light is out, the level adjustment of the machine
may still be improved. (See Manual Level Adjustment (Trim) sec-
tion).
NOTE: There is a limit switch that senses when all four cylinders are fully
retracted and this will light up the four leveling jack lights in the
platform control station.
The proximity sensor will not allow the jacks to be extended or
retracted when the machine is elevated. If there is a proximity
sensor failure the leveling jacks cannot be used.
Manual Level Adjustment (Trim)
NOTE: There is an override feature on the leveling jack system that
allows the operator to adjust (trim) the level of the machine to
the left or right when the platform is completely lowered. Use the
following instructions to adjust the level of the machine.
1. With the machine in the stowed position, turn the power on,
start machine.
2. Press the leveling jacks button on the front of the platform
control box.
3. To adjust (trim) the machine to the right, activate the steer
switch on the top of the joystick to the right until the desired
position is reached.
4. To adjust (trim) the machine to the left, activate the steer
switch on the top of the joystick to the left until the desired
position is reached.
NOTE: Anytime the trim function is used there is a possibility that the
machine may become out-of-level. At this time the machine will
no longer lift but the machine can be lowered.
NOTE: The machine must be in the stowed position before the trim
function is operable.
To Next Page
Loading...
