SECTION 4 - EMERGENCY PROCEDURES
4-4 31217162
Righting of Tipped Machine
A forktruck of suitable capacity or equivalent equipment should
be placed under the elevated side of the chassis, with a crane or
other suitable lifting equipment used to lift the platform while
the chassis is lowered by the forklift or other equipment.
Post-Incident Inspection
Following any incident, thoroughly inspect the machine and test
all functions first from the ground controls, then from the plat-
form controls. Do not lift above 10 ft (3 m) until you are secure
that all damage has been repaired, if required, and that all con-
trols are operating correctly.
Platform Manual Descent Control
The platform manual descent control is used in the event of total
power failure to lower the platform using gravity. The red T-han-
dle is located at the rear of the machine behind the ladder. Look
for the instruction decal located beside the handle.
1. Locate the red platform manual descent control T-handle.
KEEP HANDS AND ARMS OUT OF THE PATH OF THE SCISSOR ARMS AND PLATFORM
WHILE LOWERING.
2. Grasp the T-handle and slowly pull out to lower the scissor
arms/platform. When the platform is lowered to the desired
level, release the T-handle.
To Next Page
Loading...
