SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-10 31217162
2.5 FUNCTION CHECK
Perform the Function Check as follows:
1. From the Ground Control Panel with no load in the platform:
a. Ensure all guards protecting switches are in place.
b. Operate all functions (refer to Section 3.6 for Ground
Controls and Indicators).
c. Ensure that all machine functions are disabled when
the Emergency Stop Button is activated.
d. Check that auxiliary descent, lift down operates with
engine off and power on.
e. Check that manual descent operates properly (refer to
Section 4.4 for more information).
2. From the Platform Control Console:
a. Ensure the control console is firmly secured in the
proper location.
b. Ensure all guards protecting switches are in place.
c. With the platform elevated on a smooth, firm, level sur-
face with no overhead obstructions, drive the machine
to check if the high drive cutout speed limit is engaged
at the height indicated in Table 2-1:
d. Ensure that all machine functions are disabled when
the Emergency Stop Button is activated.
e. Ensure all machine functions stop when function con-
trol is released or when joystick trigger is released.
Table 2-1. High Drive Speed Cutout Height
Model Height
RT2669, ERT2669 70 in (1.78 m)
RT3369, ERT3369 80 in (2.03 m)
To Next Page
Loading...
