SECTION 3 - MACHINE CONTROLS, INDICATORS, AND MACHINE OPERATION
3-34 31217162
3.14 QUIKLEVEL ADVANCED (DUAL OSCILLATING AXLES)
(IF EQUIPPED)
The machine may be quipped with QuikLevel Advanced, auo-lev-
eling dual oscillating axles with a manual adjust feature. These
axles are activated through a switch on the platform control con-
sole.
Auto-Leveling
1. With the machine in the stowed position, turn the power on,
start machine.
2. Press the dual oscillating axles button on the front of the
platform control box.
3. While squeezing the trigger switch on the joystick, move the
joystick forward to begin leveling the machine.
NOTE: Due to varying ground conditions, there may be several delays
between machine level corrections. Be sure ample time is
allowed for all leveling adjustments to be completed.
NOTE: The level adjustment of the machine may still be improved. Refer
to Manual Level Adjustment (Trim) for more information.
4. Continue to hold the joystick forward until the leveling
sequence ends and the platform alarm sounds three times
to indicate this is complete.
5. To realign the chassis with the rear axle, press the function
button, then move the joystick backwards. The platform
alarm will sound two times to indicate this is complete.
NOTE: If a 2/5 flash code through the system fault light at the platform
control station while driving in the stowed position, reattempt to
realign the chassis and the rear axle.
NOTE: The tilt indicator shows when the machine is outside the allow-
able lifting operation. When the machine reaches a position
within level of the specific market specification, the tilt light will
go out. Once the light is out, the level adjustment of the machine
may still be improved. (See Manual Level Adjustment (Trim) sec-
tion).
To Next Page
Loading...
