6-5
GYRO/RECEIVER/BATTERY INSTALLATION
Wrap the receiver/gyro
amplifier in sponge or
foam rubber to protect
from vibration.
Gyro Amplifier
Sponge/Foam Rubber
Gyro Unit
Receiver
Be certain when installing the gyro unit to the front radio bed that it does not come in contact with the frame of the
helicopter, etc. Also make sure that the front radio bed is free from oil and debris. Clean with rubbing alcohol if
necessary to insure proper adhesion.
Note:
Double-Sided Servo Tape
Double-Sided Servo Tape
Ni-Cd RX Battery Pack
1400mAh
minimum
Double-sided servo tape
and sponge/foam rubber
are not included in this kit.
Note:
To Next Page
Loading...
