GPS Navigator J-NAV500
38
1. Setting position display type
(1) Turn in the [POSITION MEN] display mode to select the [L/L OR TD] menu.
[L/L OR TD] is highlighted and currently selected item [L/L] is displayed.
(2) Press to confirm [L/L OR TD] selection.
All selected items are displayed and currently selected item [L/L] is highlighted.
(3) To change to [TD], turn to select [TD] and press to confirm.
(When [L/L] is the selection you wish to make, press to cancel the last selection.)
This action returns you to the [L/L OR TD] menu and [L/L OR TD] is highlighted.
2. Position Correction (latitude, longitude) menu setting
(1) Turn in the [POSITION MENU] display and press to select the [POS CORR]
menu. [POS CORR] is highlighted and the currently set value is displayed.
(2) Press to confirm [POS CORR].
The next item, [N] is highlighted.
(3) If [N] is the selection you wish to make, press . If you wish to select [S], turn to
select [S] and press to confirm the selection.
[00] is now highlighted.
(4) Turn to select the desired value and press to confirm the selection.
[000] is highlighted.
(5) Turn to select the desired value and press to confirm the selection. This action
corrects the latitude setting.
The next item to be set, [W] is highlighted.
(6) Repeat steps (3) to (5) to set longitude.
The [POS CORR] menu is displayed and [POS CORR] is highlighted.
(7) Press to return to the previous display.
• Use the key to amend number entries during settings.
Example: Amending a number entry made in step (3) above
When [00] has been confirmed, [000] is highlighted. Before confirming [000], press .
This action causes [00] to be highlighted and allows you to amend the [00] setting.
• Turning rapidly, changes the figures at high speed.
To Next Page
Loading...
Need help?
General
