JRC J-NAV 500 User Manual

GPS Navigator J-NAV500
51
2. Storing by TDs (TD1, TD2) (When the [TD] is selected.)
Use the following procedure to enter the position of a waypoint using time differences.
(1) Press in the [WAYPOINT] display mode. This displays the [WAYPOINT MENU] .
(2) Turn to select [ENTER NEW WPT BY TD] and press .
Display example
(3) As in 1, select waypoint number and name, and press .
(4) Enter TD1 and TD2. (When the [TD] is selected.)
[GRI] displayed in the [TD conversion input] is [ESTIMATED TD] made in [STATUS/SF MENU] (See
Section 4.19.3, “TD initializing”)
3. Storing by bearing and distance
Use the following procedure to enter bearing and distance to be used in calculating waypoint position.
(1) Press in the [WAYPOINT] display mode. This displays the [WAYPOINT POINT] .
(2) Turn to select [ENTER NEW WPT BY B/R] and press .
Display example
(3) As in 1, enter waypoint number and name, and press .
(4) The bearing and distance from current position is entered.
When the entry is complete, the message “CALCULATING” is displayed.
[First Display]
[WAYPOINT
MENU]
[WAYPOINT
MENU]
[Display showing made entries]
[First Display]
[Waypoint
Menu]
[Waypoint
Menu]
[Display showing made entries]

JRC J-NAV 500 Specifications

General

Brand	JRC
Model	J-NAV 500
Category	GPS
Language	English