EasyManuals Logo

JRC J-NAV 500 User Manual

JRC J-NAV 500
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
GPS Navigator J-NAV500
53
2. Copying waypoints
(1) Press in the [WAYPOINT] display mode.
(2) Turn to select [ERASE/COPY/MEASURE] and press .
(3) Turn to select [COPY WAYPOINT] and press .
(4) Enter the number of the waypoint to be copied in the [FROM] field.
(5) Enter the number of the destination of the waypoint in the [TO] field. The waypoint has been
copied.
If the number of an already registered waypoint is selected as the destination, it will be overwritten by
the copied waypoint.
2. Measuring between waypoints
(1) Press in the [WAYPOINT] display mode.
(2) Turn to select [ERASE/COPY/MEASURE] and press .
(3) Turn to select [MEASURE WAYPOINT] and press .
(4) Enter the number of the waypoint to be used as the origin in the [FROM] field.
(5) Enter the number of the waypoint to be used as the end point in the [TO] field.
The bearing and the distance between the waypoints is calculated and the result is displayed at the
bottom of the screen.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JRC J-NAV 500 and is the answer not in the manual?

JRC J-NAV 500 Specifications

General IconGeneral
BrandJRC
ModelJ-NAV 500
CategoryGPS
LanguageEnglish

Related product manuals