JRC J-NAV 500 - Output level setting; Output data setting; Transmitting Memory Data

GPS Navigator J-NAV500
63
1. Output level setting
(1) Press in the [STATUS] display mode.
This action displays the [STATUS/SF MENU] .
(2) Turn to select [SPECIAL FUNCTION] and press .
The [SF MENU] display mode appears.
(3) Turn to select [DATA OUTPUT] and press .
The [SF MENU DATA OUTPUT] display mode appears.
(4) Turn to select [OUTPUT LEVEL] and press .
(5) Set [OUTPUT LEVEL] ( RS-422 / TTL (default))
2. Output data setting
(1) Press in the [STATUS] display mode.
This action displays the [STATUS/SF MENU] .
(2) Turn to select [SPECIAL FUNCTION] and press .
The [SF MENU] display mode appears.
(3) Turn to select [DATA OUTPUT] and press .
The [SF MENU DATA OUTPUT] display mode appears.
(4) Turn to select [NMEA0183] and press .
(5) Set the version of NMEA0183 ( 1.5 (default) /2.1 ).
3. Transmitting Memory Data
(1) Press in the [STATUS] display mode.
This action displays the [STATUS/SF MENU] .
(2) Turn to select [SPECIAL FUNCTION] and press .
The [SPECIAL FUNCTION] display mode appears.
(3) Turn to select [MEMORY IN/OUT] and press .
This displays the [SPECIAL FUNCTION MEMORY IN/OUT] display mode.
(4) Memory Data Output
Waypoint and route plan data can be uploaded separately to external equipment such as a PC.
This data can be saved and edited on external equipment.
During the upload the message [UPLOADING] is displayed. The time required for the transfer
depends on the amount of data transferred.
• Waypoint data output
Select [OUTPUT WPT DATA] and press .
• Route plan data output
Select [OUTPUT ROUTE DATA] and press .