GPS Navigator J-NAV500
72
Operation messages
Message Description
EVENT FULL Too many events (waypoints) registered. This message is displayed when an
attempt is made registered a new event.
Delete old data before making new registration.
WPT FULL
Too many waypoints registered. Delete old data before making new registra-
tion.
This message is displayed when an attempt is made to set a waypoint by enter-
ing positions, bearings or distance.
NO WAYPOINT No waypoint has been registered.
Register a waypoint.
ROUTE FULL Too many routes registered. Delete old data before making new registration.
NO ROUTE No route has been registered.
Register a route.
A registered waypoint number has been specified in the registration of an event.
Register the event in a free waypoint number.
Confirmation message asking if a waypoint or route plan should be deleted.
Press to delete. To cancel deletion, press .
CALCULATING The program is calculating distance or position of waypoint or route plan.
Please wait.
DOWNLOADING
The unit is downloading data from external equipment. Please wait.
UPLOADING The unit is uploading data to external equipment. Please wait.
SIM The simulator mode is on. To exit simulator mode, turn it off.
WPT NO DEST No waypoint was set in a route plan or in direct route.
NOW USING,
IN ROUTE,
DEST PT
ARE YOU SURE?
ENT
To Next Page
Loading...
