4-12
4.2.12. Entering a numeric value
This section describes the procedure for entering a numeric value.
Procedure
1. Move the cursor to the field in which a value is to be entered by using
.
2. Set a numeric value to be entered by using
and press or .
3. Move the cursor to the right most field and press
or . The setting value is confirmed.
Select a field by using
Select a numeric value by using
If the numeric value that can be entered is restricted by an input range, enter the digits from the
highest order.
To prevent the value from exceeding the input range, the input of the low-order digits is restricted
by the value of the high-order digit.
Example) The input range is from 1 to 10:
If 1 is input in the high-order digit, only 0 can be set as the low order digit.
Power must not be off for 10 seconds after setting. When not doing so, the setting value may not
be saved.
Supplement
To Next Page
Loading...
