JRC NWZ-4610 - Mounting Using a Flash Mount

6-6
6.2.3. Mounting using a flash mount
Use the following procedure.
See the diagram below for the mounting space and mounting holes.
Do not tighten a screw too much. Doing so may result in damage of installation holes.
(1) Insert the main unit in the installation location
(2) Fix the main unit using the mounting screws (
φ
4 screw or wood screw, L>=10mm, provided by the
shipyard).
The sizes of the heads of the screws that are used are restricted as follows including the washers.
 Diameter: Up to 8 mm
 Height: Up to 4.5 mm
(3) Insert the front panel into the main unit
Front panel
Mounting
screw
(provided by
the shipyard)
After mounting

4.5 mounting
hole (4)
Main unit
Mounting wall