4-15
4.5.2. Adjusting back light
Brightness can be changed by using
. Four levels of brightness are available, bright, medium,
dark, and off.
This section shows how to set a level value of each brightness.
Procedure
1. Display a main menu by pressing
.
2. Select “DISPLAY”, “LCD”, and “DIMMER MAXIMUM/TYPICAL/MINIMUM” in this order by using
.
3. Select a brightness value by using
and press .
4.5.3. Setting a click sound
Turn on/off a key-operation click sound.
ON: Enables a click sound. When the key is pressed, a click sound is emitted.
OFF: Disables a click sound.
Procedure
1. Display a main menu by pressing
.
2. Select “DISPLAY” and “CLICK SOUND” in that order by using
.
3. Select “ON” or “OFF” by using
and press .
4.5.4. Setting a display screen
Up to six display screens can be registered in this display unit.
The display screen can be switched either manually by using
or automatically (auto screen
function).
The auto screen function enables the setting of a switching interval. Switching can also be notified by
emitting a buzzer sound.
Only the integer section or the decimal section of a indication character can be expanded and displayed.
(Display mode)
The setting of the auto screen function and the display mode are performed by "STEP3."
The screen structures of each display screen include customized screens that can be set freely, special
screens that do not allow any setting, and graphic screens. The contents to be displayed on the
display screen can be selected.
The screen selection procedure is as follows.
STEP1 Select the display screen from user mode.
STEP2 Select a screen structure.
STEP3 Select the display contents.
Enter the highest value in “MAXIMUM” and the lowest value in “MINIMUM”.
Supplement
To Next Page
Loading...
