JRC NWZ-4610 - Setting the Water Temperature Alarm; Setting the Water Depth Alarm; Setting the Wind Velocity Alarm

4-30
4.8.5. Setting the water temperature alarm
An alarm occurs when the water temperature exceeds the set value.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Press the
key to select “ALARM” and “WATER TEMP” in order.
3. Press the
key to select “OVER,” “UNDER,” “IN RANGE,” or “OUT RANGE.”
4. Press the
key to select “OVER,” “UNDER,” “MAXIMUM,” or “MINIMUM.”
5. Press the
key to enter the water temperature, and press the key.
6. Refer to “4.8.11 Setting a buzzer sound and screen back light” to set the alarm sound and screen
brightness.
4.8.6. Setting the water depth alarm
An alarm occurs when the water depth exceeds the set value.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Press the
key to select “ALARM” and “DEPTH” in order.
3. Press the
key to select “OVER,” “UNDER,” “IN RANGE,” or “OUT RANGE.”
4. Press the
key to select “OVER,” “UNDER,” “MAXIMUM,” or “MINIMUM.”
5. Press the
key to enter the water depth, and press the key.
6. Refer to “4.8.11 Setting a buzzer sound and screen back light” to set the alarm sound and screen
brightness.
4.8.7. Setting the wind velocity alarm
An alarm occurs when the wind velocity exceeds the set value.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Press the
key to select “ALARM” and "WIND” in order.
3. Press the
key to select “OVER.”
4. Press the
key to select “OVER.”
5. Press the
key to enter the wind velocity, and press the key.
6. Refer to “4.8.11 Setting a buzzer sound and screen back light” to set the alarm sound and screen
brightness.