JRC NWZ-4610 - Setting a Vessel Speed Alarm; Setting a TRIP Alarm

4-29
4.8.3. Setting a vessel speed alarm
When the vessel speed reaches the set range, the alarm is issued.
The range can be selected from OVER, UNDER, IN RANGE, and OUTRANGE.
OVER: An alarm is issued when the vessel speed reaches or exceeds the set speed.
UNDER: An alarm is issued when the vessel speed is equal to or slower than the set speed.
IN RANGE: An alarm is issued when the vessel speed is between the lower limit value and the upper
limit value.
OUT RANGE: An alarm is issued when the vessel speed is equal to or slower than the lower limit
value or equal to or higher than the upper limit value.
For IN RANGE and OUT RANGE, set the upper limit value and lower limit value.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Select “ALARM” and “SPEED” in this order by using
.
3. Select “OVER, “UNDER”, “IN RANGE”, or “OUT RANGE” by using
.
4. Select "OVER", "UNDER", “MAXIMUM” or “MINIMUM” by using
.
5. Enter a vessel speed by using
and press .
6. Refer to “4.8.11 Setting a buzzer sound and screen back light” to set the alarm sound and screen
brightness.
4.8.4. Setting a TRIP alarm
An alarm is issued when the distance exceeds the set TRIP.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Select “ALARM” and “TRIP” in this order by using
.
3. Select “OVER” by using
.
4. Select “OVER” by using
.
5. Enter a distance by using
and press .
6. Refer to “4.8.11 Setting a buzzer sound and screen back light” to set the alarm sound and screen
brightness.