4-39
4.9.5.1. Setting transmission
The procedure for setting a serial port for transmission is shown below.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Select “INTERFACE” and “DATA I/O” in this order by using
.
3. Select the output format to be set by using
.
1) Selecting NMEA
4. Select “SEND” from “DATA IN/OUT” by using
.
5. When an output version is selected by using
, a sentence list is displayed.
Available versions are “1.5”, “2.1”, “2.3”, and “4.0”.
6. Select an output sentence by using
and set an output cycle.
A cycle can be selected within the range from 1 second to 9 seconds and if OFF is selected, the
sentence is not output.
7. Return control to the BIT RATE selection screen and select BIT RATE by using
.
Available bit rates are “4800”, “9600”, “19200”, and “38400”.
Sentence list
Setting port
Select an output format
Select SEND
Select BIT RATE
Select VERSION
(NMEA only)
Select an output
cycle
Select an output sentence
BIT RATE selection screen
To Next Page
Loading...
