JRC NWZ-4740 - Moving the Cursor with the Numeric Keypad and Selecting a Range

4-68
4.8.3.2 Moving the Cursor with the Numeric Keypad and Selecting a Range
The operation examples show selection of waypoints 2 to 5 in the waypoint list, but the
instructions provided apply to operation within all lists.
1. Display the list.
2. Use the numeric keypad to enter number "2" and press
to move the cursor to "2".
3. Press
to establish the start point.
4. Use the numeric keypad to enter number "5" and press
to move the cursor to "5" and
select the range.
5. Press
to establish the range.
Waypoint List
Input "2".
Move to destination number "2".
Start point "2" is established.
Input "5".
· In the list that displays only the registered number, when the input number with
numeric keypad doesn't exist, the cursor moves to a number that is the nearest the
input number.
Move to waypoint number "5"
and press to select
ran
g
e.
Start point number
End point number
Total number selected
Selection range
"2" displayed
"5" displayed
Procedure
Memo