4-54
4.6 Performing Navigation
· Registered and temporary routes can be started.
· Navigation can be performed via the following methods.
(1) Selecting a route from the route list
(2) Selecting a waypoint with the GOTO key
(3) Selecting a route with the GOTO key
(4) Creating a route with the GOTO key
· Navigation cannot be performed above 89 degrees north or south.
· Temporary routes created with GOTO use the route widths, arrival circle radiuses, and planned
speeds set as route default setting values.
Please refer to "4.5.7 Setting Route Default Settings" for details regarding setting route default
setting values.
· Waypoint switching occurs when the arrival circle is reached.
4.6.1 Selecting a Route from the Route List
Routes can be selected from the route list and started.
1. Press
, , and then to display the route start/end screen.
2. The route list will be displayed. Move the cursor to the route number you wish to start, and
press
.
Refer to "4.8.1 Moving the Cursor within a List" for details regarding cursor movement.
3. The route start/end screen will be displayed, so perform route settings.
The following is an overview of each submenu.
(1) LEG CHANGE: You can set whether LEG change is performed automatically or
manually when own ship arrives within the waypoint arrival circle.
AUTO: The waypoint automatically changes to the next waypoint.
is
displayed in the status bar.
When the arrival circle is reached, the alarm of the unit will be
sounded, and the waypoint will be updated, displaying the following.
The display will disappear automatically in 5 seconds.
When the final waypoint is reached, the arrival alarm sound
configured in the alarm settings will be sounded.
Procedure
To Next Page
Loading...
