JRC NWZ-4740 - 6.4 Optional Peripheral Connection

6-18
6.4 Optional Peripheral Connection
6.4.1 Sub Display Connection
Connect the sub display sensor connection terminal to the main display external equipment
connection terminal (serial).
Use a junction box (CQD-10).
Any main display external equipment connection terminal can be used. The following
specifications apply to the terminal.
Data format: IEC
Bit rate: 4800 bps
Sentence Sub Display: "On"
To display satellite information on the sub display, change the bit rate to "9600 bps", and add
"GSV" and "CD, GP, 3" to the sentence setting.
Set the display type to "Sub" to use the unit as a sub-display.
①
②
③
④
⑤
⑥
○
○
○
:
○
TXDB
TXDA
Sub display sensor
connection terminal
CQD-10
terminal board
Main display
external equipment
connection terminal
Main Display Sub Display
Junction Box/CQD-10
Connect to receiver connection terminal
Connect to external equipment connection terminal
DGPS Cable/CFQ-9002
Data Cable/CFQ-5374
Caution: carries voltage
Wrap this section with vinyl tape to protect.