JRC NWZ-4740 - Connecting Two Navigation Devices to a Printer

6-23
6.4.5 Connecting Two Navigation Devices to a Printer
A switch (NCZ-777) is necessary when connecting 2 GPS units to printer (DPU-414).
RS-232C connectors and printer (DPU-414) can be connected.
The RS-232C connectors for both units are configured in Data IN/OUT1. The Data IN/OUT1 data
format should be set to "printer".
Use the printer connection kit (7ZXJD0076) to extend the printer power cable.
Printer Cable (7ZCNA4109/7ZCNA4112) Pin
Connection Example
Printer/DPU-414
Connect to RS-232C connector
Printer cable (3 m)
7ZCNA4109
Switch NCZ-777
Printer cable (10 m)
7ZCNA4112
Power supply
NBG-320
DC6.5V
DPYC-1.5
MAX 8.5m
Printer connection kit
Power cable 7ZCJD0257B
and connection terminal
1
2
3
4
5
6
7
8
9
10
11
12
Black TXD No1GPS 7ZCNA4112
Blue GND No1GPS 7ZCNA4112
Black TXD No2GPS 7ZCNA4112
Blue GND No2GPS 7ZCNA4112
7ZCNA4109 RXD Red
7ZCNA4109 GND Blue
Printer
NCZ-777 Terminal
GPS Navigator
Cable Connector
3
4
7
5
Red RXD
Black TXD
Green RTS (Not Use)
Blue GND