4-104
4.20.5 Performing a Master Reset (Reset)
· The GPS sensor, display, or both can be reset.
· Resetting will restore all settings to their default values.
· To reset the display, select "ALL" or "EXCEPT FOR LISTS".
If "EXCEPT FOR LISTS" is selected, everything except the waypoint list, the route list, and the
event / mark list will be reset.
If "ALL" is selected, the display will be reset, and the waypoint list, route list, and event / mark
list will be deleted.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
"RESET".
3. Press to select the equipment to reset, and then press
.
(1) If "SENSOR" is selected, a master reset of the GPS sensor will be performed.
(2) If "DISPLAY" is selected, the display will be reset. Select "ALL" or "EXCEPT FOR LISTS",
and press
.
(3) If "ALL" is selected, a master reset of the GPS sensor will be performed, and the display will
also be reset.
The display lists will also be reset.
4.20.6 Performing a Demo
· The unit can perform a demo, where it behaves as if it is actually functioning, even without
GPS reception.
· The following is an overview of the demo type submenu.
(1) STATIC: Keeps at set position.
(2) STRAIGHT: Goes in set straight line at constant speed.
(3) RIGHT: Turns right at set turn radius.
(4) LEFT: Turns left at set turn radius.
(5) ROUTE: Performs selected route. Moves at set speed from set position to route start
point.
(6) AUTO: Moves in set direction a set distance from set position.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
, and then to select "DEMO TYPE".
3. Select demo type with , and press
.
4. Enter the demo type operation base values with the numeric keypad.
5. Press
and the demo will start.
·
To stop the demo, display the demo screen again, and press
"STOP", or turn
the power off.
·
When the demo is being performed, "S" will blink at the bottom right of the screen.
·
When the demo is being performed, "MOB" does not operate.
･
After end of demo, the setting performed during in the demo is not available.
Memo
Procedure
Procedure
To Next Page
Loading...
