4-111
4.20.7.2 Setting Data OUT2
· NMEA, JRC, IEC, route WPT, and automatic switch control data can be output via data OUT2.
1. Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2. Press
, and then to select "DATA OUT2".
From this point on, operation is identical as that described for "DATA IN/OUT1".
However, routes and waypoints can not be received from external sources as RTE and WPL
sentences.
4.20.7.3 Setting Data OUT3
· NMEA, JRC, IEC, route WPT, and automatic switch control data can be output via data OUT3.
1. Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2. Press
, and then to select "DATA OUT3".
From this point on, operation is identical as that described for "DATA IN/OUT1".
However, routes and waypoints can not be received from external sources as RTE and WPL
sentences.
4.20.7.4 Setting Data IN/OUT4
· NMEA, JRC, IEC, route, and switch data can be output via data IN/OUT4.
･ To connect Current, temperature and Depth meter, set to only bit rate and use a Pin No.1,2 in
DATA IN/OUT connector.
· The layer and data number for displaying tidal current data can be set by setting externally
connected equipment. Please refer to "4.20.7.8 Setting Tidal Current Meter Input" for setting
method.
1. Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2. Press
, and then to select "DATA IN/OUT4".
From this point on, operation is identical as that described for "DATA IN/OUT1".
Procedure
Procedure
Procedure
To Next Page
Loading...
