4-107
(2) When "IEC" is Selected
Select the bit rate, output sentence, and interval.
Sentence and Interval Setting Screen
If no sentence is displayed, the output sentence has not been selected.
4.
Press "SENTENCE".
5. Move the cursor to the sentence you wish to output, and press
.
6. The output interval is displayed. Select the interval and press
.
(3) Selecting "ROUTE" and sending data
Saved routes and waypoints are output as RTE and WPL sentences.
Select the version, bit rate, and output type.
3.
Press "DATA IN/OUT".
4. Press
to select "OUT", and then press .
5.
Press "BITRATE", and select the bit rate.
6. Press "FORMAT", and select the format.
"NMEA Ver1.5", "NMEA Ver2.1", and "NMEA Ver2.3" can be chosen as data formats.
The selected sentence is displayed.
If no sentence has been selected, no
sentence is displayed.
To Next Page
Loading...
