4-115
(3) Data output setting
3. Press
to select "DATA OUT", and press .
4. Press
"CONNECT".
5. Select the connection destination with
, and press .
"MULTICAST", "UNICAST", or "BROADCAST" can be set as connection destinations.
Normally, "MULTICAST" should be selected.
When "UNICAST" is selected, destination IP "2. To IP" and "3. Port No." can be set.
6. Press
"FORMAT".
7. Press
, select the data format, and press .
"IEC", "NMEA Ver1.5", "NMEA Ver2.1", and "NMEA Ver2.3" can be chosen as data formats.
8. Press
"SENTENCE".
9. Press
to select the output sentence, and press .
10. Press
to select the sentence output interval, and press .
11. After you have selected all sentences you wish to output, press
.
(4) Mutual monitoring mode setting
3. Select "MUTUAL" with
, and press .
4. Press
to select "ON", and then press .
To stop mutual monitoring, select "OFF".
When "ON" is selected, and select "CONNECT". Normally, "MULTICAST" should be
selected.
To Next Page
Loading...
