(7) Initialization of data
It is possible to initialize selected data (reset to factory default.).
Data Display
Pattern data
Memory switch data
All sewing machine data
❷
❺
❽
❽
❻
❻
❺
❶
❾
1
）
DDL-9000C-S
① Select the function of initializing data.
1. When you hold down the ❾ for
six seconds on the sewing screen, a
mode screen of the serviceperson level
2 is displayed.
2. After you press the ❶ and
select "13 Data initialization," press the
❺ to display the selection screen
of an initialization data.
② Select data to initialize.
1. Press the ❷ to select data to
initialize.
2. When you press the ❺ after the
above selection, the screen of mes-
sage conrming the initialization is
displayed.
The data that can be selected is as
follows:
③ Execute or cancel initialization.
1. When you press the ❽, initial-
ization is executed.
When you press the ❻, initializa-
tion is canceled and the current screen
returns to the mode screen.
④ Turn on the sewing machine again.
1. The screen for giving you instructions
to turn off the sewing machine is dis-
played after you execute initialization,
so turn off the sewing machine actually.
2. When you turn on the sewing machine
again, the sewing machine starts up in
a state where data has been initialized.
画面をご支給ください
画面をご支給ください
– 95 –
To Next Page
Loading...
Need help?
General
