(3) Operating timing of the feed
(Caution) 1. The feed timing differs with the set value. (Image gure as observed from the face plate
side)
2. The stitch length changes by adjusting the feed timing. Carry out adjustment while actually
carrying out sewing for the purpose of checking the stitch length.
❷
2. Display "S049 Feed timing" by pressing
❷.
❶
Timing between the needle and feed can be
adjusted on the operation panel.
[How to adjust]
1. Display the sewing data edit screen by
pressing ❶.
3. Change the feed timing by pressing ten
keys and +/- keys ❸.
(+ : To advance; - : To retard)
4. Conrm your entry by pressing ❹.
5. Display the sewing screen by pressing
❺.
❹❸
❺
1）DDL-9000C-F type
– 8 –
(Caution) When you have changed the stitch length, feed dog height or feed timing, run the sew-
ing machine at a low speed to make sure that the gauge does not interfere with the
changed part.
Standard : 0
Needle
To advance :
Adjust with the + key
To retard:
Adjust with the - key
To Next Page
Loading...
Need help?
General
