2. Loosen the xation screws ❹, and remove the
plate for exiting the cords.
3. Remove the connector ❺ and ❻, and then the
power cord.
(Caution) The connector has a lock mechanism.
Pull it out while pushing the lock
mechanism part.
When you change the power voltage to 100V from
200V, replace it by the power code of P/N 40175582.
When you change the power voltage to 200V from
100V, replace it by the power code of P/N 40175581.
Power cord for 100V
(JUKIpart No.：40175582)
Power cord for 200V
(JUKIpart No.：40175581)
Each time you change the factory-congured power voltage and use the changed power voltage, buy the nec-
essary parts from our service department.
he power cord differs between the 100V system and/200V system.
❸
❹
❺
❻
– 151 –
To Next Page
Loading...
